MIL-E-51223(MU)
3.2 Manufacture and assembly. The protective entrance shall be .
assembled as specified on Drawing D5-19-3046.
3.2.1 Sewed seams. All sewed seams shall be straight and regular
.
lines. AU ends shall be back stitched at least 2 inches. No loose
threads shall dangle.
3.2.2 Lap joined cemented seams, All lap joined cemented seams of
the protective entrance shall be capable of withstanding a pull of 5
pounds per inch when tested as specified in 4.3.2.2.
3.3 Preproduction. Prior to the start of regular production, a
preproduction sample of protective entrance and lap joined cemeted seams
shall be produced in accordance with this specification for examination
and test (see 4.3).
3.4 Workmanship. The protective entrance shall be free from foreign
matter (dirt, grease, oil, or viscous material) and damage (punctures,
tears, dents, scratches, or abrasions) and any sharp edges or burrs.
4. QULAITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection.
4.1.1 Suppliers responsibility. Unless otherwise specified in the
contract or purchase order, the supplier is responsible for the perfor-
mance of all inspection requirements as specified herein. Except as
otherwise specified in the contract or order: the supplier may use his
own or any other facilities suitable for the performance of the inspection
requirements specified herein, unless disapproved by the Government The
Government reserves the right to perform any of the inspections set forth
in the specification where such inspections are deemed necessary to assure
supplies and services conform to specified requirements.
4.1.2 Objective evidence. The supplier shall provide objective evi-
dence acceptable to the contracting officer that the requirements of
3.1 and section 5 for which specific inspection has not been provided
in this specification have been satisfied.
4.2 Classification of inspections. The inspection requirements
specified herein are classified as follows:
(a) Preproduction inspection (see 4.3).
(b) Quality conformance inspection (see 4.4).
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business